Understanding Hypercube Acceptable Noise
If you are looking for information about Hypercube Acceptable Noise, you have come to the right place. Best result so far with Printrboard to 1.0 V VREF at 30 mm it is somehow
Key Takeaways about Hypercube Acceptable Noise
- Swapped 2 of my A4988 with 2 DRV2285 for X and Y and microstepping to 32, setup the VREF to 0.55 V so around 1A current .
- Hypercube rattle at 40 mm/s no rattle at 20 mm/s
- I am running only 25 mm/s and the vibration is quite crazy, it doesn't affect the print but it is very annoying.
- Provided to YouTube by Virgin Music Group Dream
- Ignore the cheap hotend clone, why it is vibrating so badly any clues ?
Detailed Analysis of Hypercube Acceptable Noise
X and Y axis Stepper Motor http://www.thingiverse.com/make:281897. Tightened the belts, but still there is
I shrunk down the 4d cube and tried it without supports, it came out pretty good aside from a few strings. It did at least as well as ...
We hope this detailed breakdown of Hypercube Acceptable Noise was helpful.
